Sony SRX-R320, Service Manual

Page: 60 / 406

1-52 (E)
SRX-R320
S/N 120001 or later: S RX-R320
S/N 800001 or later: S RX-R320S
1. Remove the panel (U7) block assembly. (Refer to Section 1-3-2.)
2. Remove the lamp base cover. (Refer to step 4 in Section 1-4-5.)
3. Open the panel (U4) block assembly. (Refer to steps 1 and 2 in Section 1-3-9.)
4. Disconnect the harness from the connector (CN202) on the DST-27 board.
5. Remove the two screws (PSW4
x
10).
6. Remove the hook portion of the cover (LCD) from the frame, then remove the cover (LCD) in the
direction of the arrow.
7. Remove the four screws (PS3
x
6) and disconnect the harness from the connector (CN5) on the
LED-488 board, then remove the LCD panel and LED-488 board.
8. Disconnect the two harnesses from the connectors (CN1 and CN2) on the LED-488 board, then
remove the LED-488 board.
9. To install, reverse the removal procedure.
Fig. 1-5-7b
PS3
x
6
PS3
x
6
Cover (LCD)
LED-488 board
DST-27 board
CN5
Harness
Harnesses
Harness
CN1
CN202
CN2
LCD panel
PSW
4
x
10