Sony PMW-200, Service Manual

Page: 69 / 134

2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer” .)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly” .)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly” .)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly” .)
6. Remove the SxS slot assembly. (Refer to “2-7-1. SxS Slot Assembly” .)
7. Remove the front panel assembly. (Refer to “2-8-1. Front Panel Assembly” .)
8. Remove the rear panel assembly. (Refer to “2-9. Rear Panel Assembly” .)
9. Remove the IO-255 assembly. (Refer to “2-11. IO-255 Board” .)
10. Remove the main heat spreader DCP. (Refer to “2-12. DCP-56 Board” .)
11. Remove the handle assembly. (Refer to “2-13-1. Handle Assembly” .)
12. Remove the front lens assembly. (Refer to “2-14-1. Front Lens Assembly” .)
Procedure
1. Remove the six screws to detach the BI retainer bracket.
P2 x 4
P2 x 4
P2 x 4
P2 x 4
BI retainer bracket
2. Remove the harness and three fine-wire coaxial cables from the six claws.
3. Disconnect the two BI boards from the two connectors CN100, CN200 on the HN-399 board.
4. Remove the two screws.
PMW-200/PMW-EX280
2-39