Sony PCM-7040, Operation Manual

Page: 71 / 91

Chapter 7
7-12
Chapter 7 Menu Operations
The display that
appears and the
meaning of the
display
Data Functions
The display that
appears and the
meaning of the
display
Data Functions
: punch in/out when you
press the REC key in the
audio insert mode
Changes the monitoring
mode according to the tape
running mode.
: does not switch
automatically
oFF*
: REPRO (when the PLAY/
REC/CUE mode)
INPUT (the other modes)
on
Auto inP (AUTO
INPUT)
PuncH io (PUNCH IN/
OUT)
EnAbLE
diSAbLE*
Selects the punch in/out
mode with the REC key.
: does not punch in/out when
you press the REC key
AtF SEnS (ATF SERVO
SENSITIVITY)
Selects the sensitivity when
the servo lock changes to
unlock.
: normal
PLAy : Low sensitivity
Effective when the audio
signal is normal, but the
servo is frequently unlocked
with the tape which has low
linearity is played back.
[SEt dSP] (SETUP
DISPLAY MENU)
Selects to open the setup
menu of the display.
: close
cLoSE*
: open
Adjusts the brightness of the
display on the front panel.
: a maximum bright level
1)
FL diSP (DIMMER)
d-1*
: a 2nd bright level
1)
d-2
: a 3rd bright level
: a minimum bright level
1) The brightness is
automatically dimmed out
when no tape is inside the
unit or the unit is set to
standby off mode (auto
dimmer function).
d-3
d-4
Auto*
oPEn
Selects the peak hold mode
of the level meters.
: holds the peak level as long
as the time you set in
“Hold-t” in the setup menu.
: keeps on holding the peak
level until you press EJECT
key or until you press the
RESET key while holding
down the DATA key.
HoLd
P-HoLd (PEAK HOLD
MODE)
nor*
Selects the release time for
the level meters.
: 50 msec
o-HoLd (OVER HOLD
MODE)
on*
: The segments are not kept
lit.
Selects the peak level hold
time of the level meters.
: 1.5 sec
: 4 sec
: 100 msec
oFF
4_0
50*
1_5*
HoLd-t (PEAK HOLD
TIME)
rLS-t (RELEASE TIME)
Selects the hold mode of the
“OVER” segments of the
level meters.
: The segments are kept lit
according to the peak hold
mode setting by “P-HoLd”.
100
7-3 Dial Menu Operations
: 2 Word
: 3 Word
: 4 Word
:
: 7 Word
2
3
4*
:
7
o-SEnS (OVER LEVEL
SENSITIVITY)
[SEt SP] (SETUP
MENU)
Selects to open the signal
processing menu of the
setup menu.
: close
: open oPEn
cLoSE*
Selects the condition that
causes the PB CONDITION
indicator on the front panel to
light.
: lights if the error rate
increases and interpolation
or muting might occurs
Pb cond (PB
CONDITION TALLY)
bAd
cond*
: lights when an error occurs
and interpolation is done
corr
Selects the level detection
sensitivity that lights the
“OVER” segments of the
level meters.
: 1 Word
: lights when an error occurs
and a correction is made
intP