Sony NU-IP40S, Instructions For Use Manual

Page: 30 / 33

30
DIP Switch Settings
When performing remote configurations via a network, set all the DIP switches to their OFF (i.e., factory default)
positions.
DIP switch 1
(

: Necessary; –: Not necessary)
Settings for numbers [3] to [7]
1) Only 3D-Dual Stream is supported.
2) 2-sample interleave division
3) Square division
4) SQ will be converted to 2-SI on the sender side.
Number Setting Description Sender Receiver
[1] Operation setting Always set to ON.
 
[2]
Compression mode
setting
OFF: Transmit compressed images.
ON: Transmit uncompressed images.
Images that are HD will always be transmitted uncompressed,
regardless of this switch setting.
[3] - [7] Video format setting Refer to the following section.
 
[8]
Downconvert output
setting
OFF: Disable downconverted output.
ON: Downconvert 4K (4096×2160 / 3840×2160) video to HD
(1920×1080) outputs on the receiver.
–

Number
Input video format 3G-SDI mapping 4K format
[3] [4] [5] [6] [7]
OFF
OFF
OFF
–
–
1920x1080/50i
–
–
ON 1920x1080/59.94i
ON
OFF
OFF 1920x1080/50p Level A/B
ON 1920x1080/50i Level B-DS
1)
ON
OFF 1920x1080/59.94p Level A/B
ON 1920x1080/59.94i Level B-DS
1)
ON
OFF
OFF
–
OFF
3840x2160/50p
Level A/B 2-SI
2)
ON Level A/B SQ
3) 4)
ON
OFF
3840x2160/59.94p
Level A/B 2-SI
2)
ON Level A/B SQ
3) 4)
ON
OFF
OFF
4096x2160/50p
Level A/B 2-SI
2)
ON Level A/B SQ
3) 4)
ON
OFF
4096x2160/59.94p
Level A/B 2-SI
2)
ON Level A/B SQ
3) 4)