19
Note
Dynamic IP address assignment using DHCP is not
supported during manual configuration mode.
Compression Mode Settings
Configure the compression mode (compressed or
uncompressed) used when transmitting 4K video
(4096×2160, 3840×2160) from the sender. The
uncompressed mode will always be used for video that is
HD (1920×1080).
Notes
To enable network redundancy for 4K video, set the
compression mode to compressed mode.
When using compressed mode, be sure to check the
picture quality before surgery begins. If a problem
exists, switch the compression mode to uncompressed
mode, or discontinue use of the unit.
When transmitting 4K video in uncompressed mode,
be sure to connect two network cables.
Network Redundancy Settings
Configure network redundancy. When this is
configured, transmission can continue even if one of the
network cable connections is severed. When this
function is enabled, be sure to connect two network
cables.
Notes
When transmitting 4K video with the compression
mode set to uncompressed mode, network
redundancy will be disabled.
When operating with a single network cable, be sure to
connect it to the MAIN network connector.
3D Video Settings
Configure the conversion mode used for 3D video input.
1) Video will not be displayed properly if the line-by-line format
is transmitted in a compressed state.
Note
During 3G Quad SQ input, conversion from line-by-line
to top-and-bottom cannot be performed and video will
not be displayed properly in compressed mode.
Attaching the DIP Switch Cover
Replace the DIP switch cover, and secure it with the
screw.
Caution
After configuring the settings, be sure to attach the DIP
switch cover and secure it with the screw. The unit
should always be operated with the DIP switch cover
attached.
Output video format
Compression mode
DIP switch 1
[2]
3840×2160 or
4096×2160
Compressed
OFF
Uncompressed
ON
1920×1080
Uncompressed
OFF
ON
DIP switch 3
Network redundancy
[6]
OFF
Disabled
ON
Enabled
DIP switch 3
3D video conversion
[5]
OFF
During 3G Quad SQ input, the line-by-line
format is detected automatically and converted
to top-and-bottom before transmitting and
output.
1)
ON
When line-by-line auto-detection does not
function during 3G Quad SQ input, conversion
from line-by-line to top-and-bottom is forced
before transmitting and output.
