![background image](http://html.mh-extra.com/html/sony/lbt-g200k/lbt-g200k_operating-instructions-manual_1329847006.webp)
Chapter 1: Setting Up
EN
6
Inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1
Open the lid.
2
Insert two R6 (size AA) batteries.
Match the + and – to the diagram in the
battery compartment.
3
Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Setting the Clock
The built-in clock shows the time in the
display.
1
3,5
1
Keep pressing CLOCK SET until the
hour indicator begins flashing.
2
Set the current hour by pressing
4
or
$
(CURSOR CONTROL) until the correct
hour appears.
3
Press CLOCK ENTER/NEXT .
The minutes indicator begins flashing.
4
Set the current minute by pressing
4
or
$
until the correct minute appears.
5
Press CLOCK ENTER/NEXT.
Use the time signal to set the clock
accurately.
“OK” appears in the display and the
clock starts running.
To check the time while power is on
Press DISPLAY.
The current time appears for a few seconds.
To correct the clock setting
Repeat steps 1 to 5.
flashing
flashing
flashing
2,4
DISPLAY
flashing