1-2
HVR-DR60
ENGLISH
JAPANESE
ENGLISH
JAPANESE
X
i.LINK
I:
ATA
A:
Power Supply
P:
Button
K:
MPEG/AVI
M:
Other
X:
Fatal Error
F:
1-2. DESCRIPTION ON SELF-DIAGNOSIS DISPLAY
When an error occurs the following warning indicators may appear on the LCD screen.
And this unit is sent error code to camera.
Self-diagnosis display : X:Yy:ZZ
X
Yy
ZZ
Description
I
12
ZZ
Returnable i.LINK-related error (The code that is corresponded to ZZ, is representative for status of i.LINK..)
A
12
ZZ
Returnable HDD-related error (The code that is corresponded to ZZ, is representative for error of ATA..)
12
ZZ
Error is occurred when the power supply -related command is sent from Main controller to Sub controller. (ZZ is
P
given value)
21
01
In case that error has been occurred with power supply controller of each device using by Sub controller.
02
Cannot enter into sleep mode
M
12
ZZ
Stream processor abnormally (ZZ is given value. Such as, when AVI format is differed, ZZ becomes 01 etc.)
11
01
HDD failure
02
i.LINK error
12
ZZ
In case that error has been detected into file system etc.
F
21
ZZ
In case that cannot communicates to Sub controller
22
ZZ
In case that cannot controls the others device from Sub controller
91
ZZ
Others, fatal error related with hardware
92
ZZ
Others, fatal error related with software
X
99
ZZ
In case that for DV SIGNAL PROCESSOR (IC501), error code etc. of firmware is to displaying.
Principal Eroor Code
X
Yy
ZZ
Countermeasure
Description
12
01
Turn the unit back on again.
Overflow of receiving buffer.
02
Turn the unit back on again.
FAT error.
A
90
01
Store the unit at room temperature for a little
Caution the unit to low temperature.
11
Store the unit at room temperature for a little
Caution the unit to high temperature.
91
01
Turn the unit back on again.
Detect the communication error with selecting the
computer mode.
11
01
Turn the unit back on again.
HDD has failed, or communication error between HDD.
12
01
Format the HDD
HDD format error.
F
20
01
Turn the unit back on again.
Unit failed PHY (Physical Layer) reset.
29
00
There is partucularly no solution. (In this case,
No writing into the sub controller firmware.
perform the firmware updates automatically.)
Y
Main
1y
Sub
2y
Other
9y
y
Physical
Y1
Logical
Y2
Other
Y9
ZZ
When error is defined
in the devise, the error
code of it is displayed.
