1 (E)
HKSP-R80
Purpose of this manual
This manual is an installation manual of Routing Switcher
Controller HKSP-R80 and Routing Switcher Backup CPU
HKSP-R81.
This manual is intended for use by trained system and service
engineers, and describes information regarding installation.
Related manuals
Besides this installation manual, the following manuals are
available for the HKSP-R80/R81.
.
System Setup Manual (Supplied with HKSP-R80)
This manual describes the software initialization or
operation confirmation.
.
Maintenance Manual (Available on request)
This manual describes the information that premises the
parts level service (adjustment, parts list, diagrams, etc.).
If this manual is required, please contact your local Sony
Sales Office/Service Center.
.
Protocol Manual (Available on request)
This manual describes the protocol for controlling this
unit. The manual below is provided for the protocol that
this unit can support.
If this manual is required, please contact your local Sony
Sales Office/Service Center.
S-BUS PROTOCOL AND COMMAND SPECIFICATIONS
(S-BUS remote terminal control protocol)
Part No.: 9-977-477-1X
.
“Semiconductor Pin Assignments” CD-ROM (Available
on request)
This “Semiconductor Pin Assignments” CD-ROM
allows you to search for semiconductors used in B&P
Company equipment.
Part number: 9-968-546-XX
1. Installation
The HKSP-R80 consists of the main board (CPU-355
board), connector panel (CN-2334 board/CN-2335 board),
unit label (2), CD-ROM (1) (backup software, routing
switcher remote control software, S-BUS subnet controller,
installation manual, system setup manual), 75
Z
terminator
(3), and T-type bridge.
The HKSP-R81 is available as an optional board (for
backup purpose) of the HKSP-R80. Installing HKSP-R81
together with HKSP-R80 in the PFV-SP series always
enables the CPU backup operation. In this manual, the
CPU-355 board performing main operation is described as
“main CPU” and the other CPU-355 board performing
backup is described as “backup CPU”.
Attaching HKSP-R80/R81
The HKSP-R80/R81 is designed to be installed and
operated in the signal processing unit PFV-SP series.
In accordance with the installation manual of the PFV-SP
series, be sure to attach the main board and connector panel
of the HKSP-R80/R81.
m
.
Do not touch the CPU-355 board with bare hands. When
the CPU-355 board is touched with bare hands, the
initial information stored in the mobile board may be
damaged. (“E.50” is displayed on the indicator panel.) If
there is a possibility that the initial information has been
damaged, initialize the setting data (Set the rotary switch
S804 to “D” and restart the HKSP-R80.) and set the time
again (Refer to Section 2-4 of the system setup manual.).
.
When attaching the connector panel, remove the two-slot
blank panel.
.
It is recommended to insert the first CPU-355 board in
the main slot (slot with smaller number). The CPU-355
board inserted in the main slot always operates as a main
CPU (becomes active state) when the power is turned on.
For the CPU backup operation, insert the second CPU-
355 board in the backup slot.
.
When installing the optional board HKSP-R81, insert it
into the slot that has the connector panel of the HKSP-
R80. If it is inserted in other slot, it does not normally
function as a backup controller.
