7
c
Tally lamp and switch
ON:
The tally lamp lights when a tally signal is input to the
connected camera control unit or a call signal is
generated in response to pressing the CALL button.
OFF:
The tally lamp is prevented from lighting.
d
BPU (Baseband Processor Unit) connector (optical/
electrical multi-connector)
Connect to BPU4800 Baseband Processor Unit using an
optical/electrical multi cable.
e
SDI 1 (serial digital interface 1) connector (BNC-type)
For 3G-SDI, HD-SDI or HD PROMPTER signal output.
f
SDI 2 (serial digital interface 2) connector (BNC-type)
For HD-SDI signal output.
Functions as an input when used as HD TRUNK IN.
g
PROMPTER2 connector (BNC-type)
For prompter 2 signal output.
Available only when connecting a camera control unit with a
prompter 2 input connector.
h
CALL button
When this button is pressed, the red tally lamp of the RCP-
1000 series Remote Control Panel or the MSU-1000 series
Master Setup Unit will light. Use to call the operator of the RCP
or MSU.
Operation panel
JN and SY models (for NTSC areas)
a
INTERCOM1 and INTERCOM2 controls and switches
There are PGM1 and 2 controls incorporated with a line select
switch, a MIC switch, and INCOM level control each for
intercom line 1 and 2.
PGM1 (program 1) control
Adjust the audio listening level of program 1.
PGM2 (program 2) control
Adjust the audio listening level of program 2.
MIC switch
ON:
The intercom headset microphone is turned on. The
intercom audio listening level is adjusted with the INCOM
level control.
OFF:
The intercom headset microphone is turned off. The
intercom audio listening level is adjusted with the INCOM
level control.
INCOM (intercom) level control
Adjust the intercom audio listening level.
Line select switch
Select the intercom line.
PROD:
Producer line
b
c
a
PGM1 control
PGM2 control
Line select switch
INCOM level control
d
MIC switch
