55
Appendix
Precautions
Note on laser beams
Laser beams may damage the CMOS image sensor. If you
shoot a scene that includes a laser beam, be careful not to let
a laser beam become directed into the CMOS image sensor of
the camera.
Do not subject to severe shocks
Damage to the case or internal components may result.
When finished using
Set the power switch to OFF.
Operation and storage environment
If operating the camera in low-temperature environments, it
may take up to 10 minutes, depending on the internal
temperature, before all functions are operating normally.
Store in a level place with air conditioning.
If the unit gets wet, make sure it is completely dry before
storage.
Avoid use or storage in the following places:
• Extremely hot or cold places
• Places with high humidity
• Places with strong vibration
• Near strong magnetic fields
• In places where it receives much direct sunlight, or near
heating equipment
Condensation
If the unit is suddenly taken from a cold to a warm location, or
if ambient temperature suddenly rises, moisture may form on
the outer surface of the unit and/or inside of the unit. This is
known as condensation. If condensation occurs, turn off the
unit and wait until the condensation clears before operating
the unit. Operating the unit while condensation is present may
damage the unit.
Components with limited service life
• The fan and battery are consumable parts that will need
periodic replacement.
When operating at room temperature, a normal replacement
cycle will be about 5 years.
However, this replacement cycle represents only a general
guideline and does not imply that the life expectancy of this
part is guaranteed. For details on parts replacement,
contact your dealer.
• The life expectancy of the electrolytic capacitor is about 5
years under normal operating temperatures and normal
usage (8 hours per day; 25 days per month).
If usage exceeds the above normal usage frequency, the life
expectancy may be reduced correspondingly.
Standalone operation
Images displayed when not connected to a BPU4800 are for
confirmation of menu settings. The PAINT adjustment
functions do not operate.
Camera CMOS image sensor phenomena
The following phenomena that may occur in images are
specific to image sensors. They do not indicate a malfunction.
White flecks
Although the image sensors are produced with high-precision
technologies, fine white flecks may be generated on the
screen in rare cases, caused by cosmic rays, etc.
This is related to the principle of image sensors and is not a
malfunction.
The white flecks especially tend to be seen in the following
cases:
• When operating at a high environmental temperature
• When you have raised the gain (sensitivity)
Flicker
If shooting under lighting produced by fluorescent lights,
sodium lamps, mercury-vapor lamps, or LEDs, the screen may
flicker or colors may vary.
To prevent electromagnetic interference from
portable communications devices
The use of portable telephones and other communications
devices near this camera can result in malfunctions and
interference with audio and video signals.
It is recommended that the portable communications devices
near this camera be powered off.
Error Messages
If a problem occurs during operation, a warning message is
displayed.
To display a message, set the DISPLAY switch to DISPLAY or
MENU.
Note
Note
Message
Meaning
TEMP WARNING
The internal temperature is abnormally
high.
FAN STOP
The built-in fan is not rotating properly.
SET SYSTEM CLOCK
The time/date of the internal clock
have not been set.
OHB BLOCK NG!
A problem is detected in the optical
block.
MSU RPN BUSY
RPN compensation was attempted
using the camera menu while being
operated from an external device.
Consult Sony service personnel.
VF RPN BUSY
RPN compensation was attempted
from an external device while being
operated using the camera menu.
Consult Sony service personnel.
