![background image](http://html.mh-extra.com/html/sony/hcd-md1ex-system/hcd-md1ex-system_service-manual_420809022.webp)
– 22 –
Contents
Sets continuous playback when pressed in the STOP state. Turns ON/OFF the tracking servo when pressed
during continuous playback.
Stops the continuous playback and recording.
Moves the sled to the external circumference only while the button is pressed.
Moves the sled to the internal circumference only while the button is pressed.
Switches between pit and groove when pressed.
Switches the displayed contents when pressed.
Ejects the disc.
Function
(P
(MD)
p
(MD)
)
+
=
0
CD-MD SYNC
1/u
6
(MD)
“CPLAY MID”
n
“CPLAY OUT”
n
“CPLAY IN”
3. Ending the continuous playback mode
1
Press the
^
(CD) button. The display changes to “CPLAY MODE”.
2
Press the
6
(MD) button to remove the disc.
Note:
The playback start addresses for IN, MID, and OUT are as follows. To display the playback position address on the display, press the
1
/
u
button to display “CPLAY (
)”.
IN:
40h cluster
MID:
300h cluster
OUT: 700h cluster
5-5-2. Operating the Continuous Recording Mode
1. Entering the continuous recording mode
1
Set a recordable disc in the unit. (Refer to Note 3.)
2
Press the
[/–]
button and display “CREC MODE”.
3
Press the
p
(CD) button to change the display to “CREC MID”.
4
When access completes, the display changes to “CREC (
)” and the
REC
display lights up.
Note
: The numbers “ ” displayed indicate the recording position address.
2. Changing the part to be recorded
1
When the
p
(CD) button is pressed during continuous recording, the display changes as below and the recorded part can be
changed. The
REC
display is off while changing.
2
When access completes, the display changes to “CREC (
)” and the
REC
display lights up.
Note
: The numbers “ ” displayed indicate the recording position address.
3. Ending the continuous recording mode
1
Press the
^
(CD) button. The display changes to “CREC MODE”, and the
REC
goes off.
2
Press the
6
(MD) button to remove the disc.
Note 1:
The recording start addresses for IN, MID, and OUT are as follows.
IN:
40h cluster
MID:
300h cluster
OUT: 700h cluster
Note 2:
The
^
(CD) button can be used to stop recording anytime.
Note 3:
Do not perform continuous recording for long periods of time above 5 minutes.
Note 4:
During continuous recording, be careful not to apply vibration.
5-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the
^
(CD) button immediately to exit it.
5-6.
FUNCTIONS OF OTHER BUTTONS
Summary of Contents for HCD-MD1EX - System
Page 2: ... 2 ...
Page 11: ... 11 This section is extracted from instruction manual ...
Page 93: ...115 HCD MD1EX MEMO ...