Sony FWD-32LX1R Mounting Bracket, Service Manual

Page: 17 / 142

1-9
FWD-32LX1R
1-4-6. H1 Board
Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the two screws (BVST3
x
6), then remove
the control button panel.
3. Remove the three screws (BVTP3
x
8), then remove
the H1 board.
4. Disconnect the harness from the connector (CN9100)
on the H1 board.
Installation
5. Install the H1 board in the reverse order of steps 2 to 4.
n
When attaching the control panel assembly, route the
harness through the opening.
6. Reattach the cabinet assembly. (Refer to Section 1-3-1.)
1-4-7. H2 Board
Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the bezel assembly. (Refer to Section 1-3-2.)
3. Remove the hook from the rib in the center of the
lower portion on the bezel assembly.
4. Slowly incline the H2 board in the direction of the
arrow, then remove it from the bezel assembly.
Installation
5. Install the H2 board.
n
When installing the H2 board, insert the two hooks
(upper portion) into the openings of the cabinet
assembly and push in the hook (lower portion).
6. Reassemble this unit in the reverse order of steps 1 and
2.
Harness
Harness
Control button
panel
Control button
Opening
H1 board
BVST
3
x 6
BVTP
3
x 8
Conductive cushion
Control panel
assembly
CN9100
Bezel assembly
Rib
Hook (upper portion)
Hook
(upper portion)
Openings
H2 board
Conductive cushion
Bezel assembly
H2 board
CN9200
Hook
(lower portion)