SELP1650 (E 3.5-5.6/PZ 16-50 OSS) (E PZ 16-50mm F3.5-5.6 OSS)
2-2
2-1. DISASSEMBLY
B-60
1
1
3
2
1
2
3
4
qf
qg
qd
qs
6
7
5
qa
qj
qk
qh
8
9
q;
Adhesive bond
(LOCTITE 460) or
the equivalent.
Outer Barrel
Assy
When the Outer Barrel Assy is removed, the Optical Unit may be disassembled.
To prevent the Optical Unit from being disassembled, be sure to follow
the procedure below for removing the Outer Barrel Assy.
1) Remove the Operation Barrel Assy first referring to Note 2.
2) Remove the four screws of the Outer Barrel Assy with the Optical Unit set
at the WIDE end.
3) Remove the Outer Barrel Assy while maintaining the WIDE end state of
the Optical Unit.
Be sure to maintain the WIDE end state.
Optical Unit
Operation Barrel
Assy
Note 1: Notes for Removing the Outer Barrel Assy.
Operation Barrel
Assy
Outside
Inside
Hole
Operation Barrel
Assy
1) Insert a lens jig (Chip B) into arbitrary two holes out of three holes of the Operation Barrel Assy.
2) Turn the outside of the Operation Barrel Assy to find the position where the tip of Chip B can be fully
inserted, and check that the outside and the inside of the Operation Barrel Assy turn simultaneously.
3) Turn the outside and the inside of the Operation Barrel Assy counterclockwise until you feel a click
and remove the Operation Barrel Assy.
Note 2: Removing the Operation Barrel Assy
MF-PR Hold Plate
Short thick claw
Long thin claw
Push the long claw of the MF-PR Hold Plate in the
direction of arrow inside the Outer Barrel Assy to
detach the MF-PR Hold Plate.
Note 3: Detaching the MF-PR Hold Plate
Operation Barrel Assy
(Note 1, 2)
Front Cover
MF- PR Hold Plate
(Note 3)
Mount Block Assy
Rear Light Shield Barrel
BL Contact Box Assy
Mount
Stopper Screw
Z-PI Holder
Outer Barrel Block
Outer Barrel Assy
Stationary Barrel
Zoom Cam Barrel
Switch Assy
3 Group Block Assy
2 Group Block Assy
1st Moving Frame
1st Holding Springs
1st Lens Assy
1 Group Block Assy
1st Light Shield Ring
1st Front Plate
Motor Geared Block
CL-1004 Board
Gom Bushes B (9109)
Gom Bush B (9109)
