SELP1650 (E 3.5-5.6/PZ 16-50 OSS) (E PZ 16-50mm F3.5-5.6 OSS)
HELP
Note for assembling and grease applying positions are shown.
2-3
1. Align the bayonet cutout of the Operation Barrel Assy with the bayonet of the Outer Barrel Assy as shown below.
2. Install the Operation Barrel Assy to the Outer Barrel Assy and gently turn the Operation Barrel Assy right and left to find the bayonet insertion
position, and then push the Operation Barrel Assy as far as it will go.
Outer Barrel Assy
Operation Barrel Assy
Outer Barrel Assy
Operation Barrel Assy
Bayonet cutout
Bayonet
3. Insert a lens jig (Chip B) into arbitrary two holes out of three holes of the Operation Barrel Assy.
4. Turn the outside of the Operation Barrel Assy to find the position where the tip of Chip B can be fully inserted, and check that the outside and the
inside of the Operation Barrel Assy turn simultaneously.
5. Turn the outside and the inside of the Operation Barrel Assy clockwise until you feel a click.
6. Check operation of the Operation Barrel Assy.
Outside
Inside
Operation Barrel Assy
Hole
Operation Barrel Assy
1. Fold the Flexible Board of the Switch Assy as shown below.
Switch Assy
Flexible board
2. Insert the Flexible Board of the Switch Assy into the hole in the Outer Barrel Assy.
3. Slide the hook near the mark on the Switch Assy in the direction of arrow
2
to install the hook.
4. Install the hook far from the mark.
Switch Assy
Flexible board
Hole
Outer Barrel Assy
2
2
3
1
1
Switch Assy
Switch Assy
Mark
Mark
Hooks
Hook
5. Insert the Flexible Board of the Switch Assy into the two slits inside the Outer Barrel Assy and stick the adhesive part of the Flexible Board to the
groove.
Note:
Confirm that the sensors of the Flexible Board are fit with the two outside holes of the Outer Barrel Assy.
Sensor
Holes
Sensor
Adhesive part
Slits
Outer Barrel Assy
Flexible board of
the Switch Assy
6. Insert the long thin claw of the MF-PR Hold Plate into the large hole in the Outer Barrel Assy.
7. Push the long thin claw of the MF-PR Hold Plate to the step and slide the short thick claw on the other side in the direction of arrow
3
to install
the MF-PR Hold Plate.
1
2
3
Long thin claw
Short thick claw MF-PR Hold Plate
Step
Large Hole
Outer Barrel Assy
MF-PR Hold Plate
