Sony BVP-E10 Series, Product Information Manual

Page: 73 / 204

73 Chapter 7 Location and Function of Parts and Controls
BVP-E10 Series Product Information Manual
7-6. CCU-900/ 900P, Camera Control Unit
7-6-1 Front Panel
a a a a
Red tally lamp
Illuminates when a red tally signal is received. When
the CALL button on the video camera, Master Setup
Unit MSU-700A/750, RCP-700 Series Remote Control
Panel, etc. is pressed, this lamp will go out if previously
lit, and light up if previously off. A supplied number
plate can be mounted here.
b b b b
Green tally lamp
Illuminates when a green tally signal is received. A
supplied number plate can be mounted here.
c c c c
MIC (microphone selection) switch
Used to select the type of headset microphone being
used, or to turn microphone input off.
DYNAMIC : for a dynamic microphone
OFF : turns microphone input off
CARBON : for a carbon or carbon equivalent
microphone
d
d d
d
INTERCOM (intercom volume adjustment)
control
Adjusts the intercom input level.
e
e e
e
CABLE ALARM indicator
SHORT
: This indicator illuminates when there is a
short circuit between a power supply line and the
sheath of the optical-fibre cable, or when the two
power supply lines are shorted. When this indicator
illuminates, the power supply is shut off. (If the
optical-fibre cable is long, this indicator may light
for a few seconds after the main power is turned on
until the short-circuit detection circuitry begins
operating normally. This is not a malfunction.)
OPEN : Illuminates when there is no camera
connected via an optical-fibre cable to the
CAMERA connector on the rear panel. The
indicator blinks slowly when the optical signal level
is in WARNING status, and blinks fast when it is in
CARE status.
f f f f
MAIN POWER switch and indicator
Turns the power on or off for the entire system,
consisting of the CCU-900/900P, a video camera, an
RCP-700 Series Remote Control Panel connected via
the REMOTE connector, etc. Setting the switch to the
position turns the power on, and setting it to turns it off.
The indicator is lit when the power supply is on.
g g g g
CAMERA POWER switch and indicator
Turns on/off the power to the camera head when the
MAIN POWER switch is on. Setting the switch to the
position turns the power on, and setting it to turns it off.
When a remote control panel is connected, the power
supply can be turned off with the CAM PW button on
the remote control panel, but only when the switch on
the CCU is in the "on" position
h h h h
INTERCOM connector (XLR 5-pin)
For connecting a headset. To use a headset with a
plug other than an XLR 5-pin plug, consult a Sony
service representative.
1
Red tally lamp
2
Green tally lamp
3 MIC switch
4
INTERCOM control
5
CABLE ALARM indicator
6 MAIN POWER switch and indicator
7
CAMERA POWER switch and indicator
8
INTERCOM connector