?PVT '!
<TcTa1aXSVT
C_fUbUYW^ EcUbc 7eYTU
Manually, the timer buttons have the following functions :
•
Start - Start the timer counting.
•
Stop - Stop the timer.
•
Reset - Reset the counter to 0.00.0 seconds.
Automatically, the timer can be used by setting jumper J9 on the input module(s)
that you wish to use to control the timer. Having the timer operate automatically may be useful for
timing the duration of music tracks or presenter speech. Remove the jumper J9 to disable timer
control.
When controlled by a channel fader, the timer operates in the following way. When
the fader is opened, if the timer is not already running, it will reset the counter and start the timer. If
the timer is already running when the fader is opened, the counter begins counting but freezes for 3
seconds, so that you can view and note the “start” time. After three seconds the counter will jump to
show the increasing time and will then continue.
The timer will be stopped by a manual stop. The timer can only be reset when in the
Stop mode.
'"
B_TPZTa P]S 2^]ca^[b
The speaker is used for monitoring PFL and talkback in the Control Room directly
from the mixer. Two knobs are available for adjusting the level of the PFL and T/B signals, from cut-
off at 0, to unity gain at 10. The speaker is muted automatically when the Control Room mute is
active, to prevent feedback.