?PVT ##
CT[R^ <^Sd[T
C_fUbUYW^ EcUbc 7eYTU
#"
<^Sd[T >_cX^]b P]S 9d\_Ta BTccX]Vb
The telco module can be configured in a number of different ways depending on the
jumper options set on the board. The options available are :
•
Select momentary or latched TBU Divert.
•
Select which Clean-feed bus should be used.
•
Set channel to start and stop the timer automatically.
•
Enable or disable the auto pre-fade listen.
#"
Bd\\Pah ^U 9d\_Ta BTccX]Vb U^a CT[R^ <^Sd[T
Jumper
Set Over Pins
Effect
J5
1 & 2
2 & 3
Momentary Divert.
Latched Divert.
J8
1 & 2
2 & 3
Use clean-feed bus 2 for this module ( See J12 also ).
Use clean-feed bus 1 for this module ( See J12 also ).
J9
1 & 2
None
Auto timer start.
No auto timer start.
J11
1 & 2
None
Auto pre-fade cancelled by PFL button or fader open.
Auto pre-fade cancelled by PFL button only.
J12
1 & 2
2 & 3
If J8 is set to 1 & 2, set J12 to 1 & 2 also - this jumper terminates
the cleanfeed bus.
If J8 is set to 2 & 3, set J12 to 2 & 3 also - this jumper
terminates the cleanfeed bus.
Note : Items in bold are set as default when shipped.
#"!
3XeTac BT[TRc <^\T]cPah ^a ;PcRWTS
The remote Divert for the TBU can be made either momentary or latched by setting
the jumper J5 to 1 and 2 ( for momentary ) or 2 and 3 ( for latched ). If no jumper is set, the Divert
remote does not operate.