
CaP]b\XbbX^] A^dcTa <^Sd[T
?PVT $"
C_fUbUYW^ EcUbc 7eYTU
$"
8]bcP[[X]V cWT <^Sd[T
Important Note : If your mixer has already been fitted with this module, you need
only note that the Master Output of the mixer should be taken from this module, instead of from the
rear of the Output Module. The external sources are not routed through the Output Module and so, do
not appear on it.
When the Transmission Router module is installed, the cabling within the mixer is
altered so that the metering can be monitored directly from this module, as opposed to through the
Output Module.
It is essential that the Transmission Router module is installed immediately to the
left of the Output Module, so that the supplied cables will be long enough. Installing the Transmission
Router Module can be achieved as follows :
•
Remove the Output Module and the panel to the left of it.
•
The Output Module is made up of four PCB’s attached vertically to the front panel. The leftmost
PCB from the front, Output Board A, has the connection for the meter panel. Disconnect the meter
connector from Output Board A and connect it to the Transmission Router Module in connector
position CN4. There should be no connection to the meter connector on Output Board A.
•
On the Output Module, there is a small cable that attaches to all four PCB’s. The Transmission
Router Module is supplied with a small 16 way cable assembly with five connectors on it. Replace
the existing cable on the Output Module with the new cable and connect the spare left hand
connector to the Transmission Router Module in connector position CN3.
•
There are no jumper settings or options available for the Transmission Router Module, so it can be
plugged straight into the mixer chassis, once the cables have been fitted. Reinstall the Output
Module and the Transmission Router Module ensuring that the bus connector is fitted to the
bottom of each of the PCBs in the modules.
•
Swap the output connectors from Output Module A to the Transmission Router Module.
Your mixer is now fitted with the Transmission Router Module.