3dP[ BcTaT^ ;X]T 8]_dc <^Sd[T
?PVT "$
C_fUbUYW^ EcUbc 7eYTU
""!
BT[TRc AT\^cT BcPacBc^_ U^a ;X]T 8]_dc ^a !
There is just one set of remote start and stop connections for both Line Inputs 1 and
2. Jumper J3 selects which input is connected to the piece of equipment that needs to be controlled
remotely. With J3 set over pins 1 and 2, the remotes will only operate when Input 2 is selected. With
J3 set over pins 2 and 3, the remotes will only operate when Input 1 is selected.
If J3 is not set, the remote start and stop will operate whether Input 1 or Input 2 are
selected.
"""
4]PQ[T 2^]cX]d^db <^\T]cPah BcPac 5a^\ >] 1dcc^]
The On button can be made to remotely Start and Stop external equipment. If you
require each press of the On button to just send a Start signal, then set jumper J4. This might be useful
for a piece of external equipment which only has one remote input for starting and stopping.
If jumper J4 is not Set, each press of the On button will alternately send Start and
Stop signals.
""#
BcPac BT[TRc <^\T]cPah ^a ;PcRWTS
The remote start can be made either momentary or latched by setting the jumper J5
to 1 and 2 ( for momentary ) or 2 and 3 ( for latched ). If no jumper is set, the Start remote does not
operate.
""$
Bc^_ BT[TRc >] 5PSTa 3^f] ^a FXcW 1dcc^] D_
The input which is being remotely started can be remotely stopped as well. There
are two options available for stopping : To remotely stop when the fader is down, set the jumper J6
over pins 1 and 2. To remotely stop when the fader is down or the On button is pressed up, set J6 over
pins 2 and 3.
""%
BTc c^ BcPac cWT CX\Ta 0dc^\PcXRP[[h
Each of the channels can be configured so that the timer on the meter bridge is
controlled by the use of the fader. This may be useful for timing the duration of music tracks. Set
jumper J9 to control the timer with the module fader being configured. Remove jumper J9 to disable
timer control.
When controlled by a channel fader, the timer operates in the following way. When
the fader is opened, if the timer is not already running, it will reset the counter and start the timer. If
the timer is already running when the fader is opened, the counter begins counting but freezes for 3
seconds, so that you can view and note the “start” time. After three seconds the counter will jump to
show the increasing time and will then continue.
The timer will be stopped by a manual stop. The timer can only be reset when in the
Stop mode.
""&
3XbPQ[T cWT AT\^cT Bc^_ 5d]RcX^]
The remote Stop function can be disabled by setting J10. Leaving the jumper off
enables the remote Stop function.
""'
2P]RT[ cWT 0dc^\PcXR ?aTUPST ;XbcT]
The PFL function can be cancelled by the fader opening or by using the PFL button
if jumper J11 is set. When Jll is off, the PFL function is not cancelled by the fader open signal.