Reference Monitors User Handbook
13
REFERENCE MONIT
ORS RM-2S4 & RM-2S10
REFERENCE MONITORS RM-2S4 & RM-2S10
1
approximately two seconds and the button will flash periodically to show that this control
is active. To turn the audio delay off, simply perform the same procedure. The DIM audio
modifier affects the audio as normal. Before this function can be used, it must first be
enabled through the SCi software in the system screen.
CUT L & CUT R Audio Modifiers
When on, the CUT L and CUT buttons are illuminated and the corresponding channel of the
selected audio source is muted.
The CUT L and CUT R modifiers may also be simultaneously activated by an external signal
applied to the rear panel remote control port. Both CUT buttons will illuminate when such
an external signal is active.
The CUT modifiers will affect the loudspeaker audio, line-level audio outputs, phase meter
reading and also, by default, the main meter readings (refer to the Main Meters section of
this manual).
Speaker Cut Control
The CUT L audio modifier has a secondary function which is used to mute the speakers
and is similar to the SPEAKER MUTE remote input pin. To use the speaker cut control, hold
down the CUT L button for approximately two seconds and the button will flash periodically
to show that this control is active. To turn the speaker cut off simply perform the same
procedure. Audio is still present at the headphone and line outputs and the front panel
modifiers affect this audio as normal. Before this function can be used, it must first be
enabled through the SCi software in the system screen.
Line Output Cut Control
The CUT R audio modifier has a secondary function which is used to mute the line outputs.
To turn the line output cut control on, hold down the CUT R button for approximately two
seconds and the button will flash periodically to show that this control is active. To turn the
speaker cut off simply perform the same procedure. Audio is still present at the headphone
and speakers and the front panel modifiers affect this audio as normal. Before this function
can be used, it must first be enabled through the SCi software in the system screen.
MONO Audio Modifier
When on, the MONO button is illuminated and the left and right channels of the currently
selected stereo audio source are summed into a monophonic signal prior to further
processing and reproduction. Scaling is such that a stereo signal measuring 0dBu on both
channels will generate a mono signal measuring 0dBu on both channels.
The MONO modifier will affect the loudspeaker audio, line-level audio outputs, phase meter
reading and also, by default, the main meter readings (refer to the Main Meters section of
this manual).
PHASE INVERT Audio Modifier
When on, the PHASE INVERT button is illuminated and the right channel of the currently
selected stereo audio Source is inverted (phase shifted by 180 degrees) prior to further
processing and reproduction.