Page 30
8. Click
Check
. The Active Directory Agent Status window is displayed. If the Directory
Services Connector is detected, the message
Directory Services Connector is
ready
is displayed.
9. Click
OK
twice to exit.
At the end of step 8, if you see the message,
Directory Services Connector is not
responding
, test connectivity from the SonicWALL CSM to the SonicWALL
ADConnector:
1. In the management interface, click
System
and then click
Diagnostics
.
2. In the
System > Diagnostics
page, Select
Ping
from the
Diagnostic Tool
list.
3. In the
Ping host or IP address
field, enter the IP address of your SonicWALL
ADConnector and click
Go
.
•
If the SonicWALL Directory Services Connector is not responding check that the
computer with the SonicWALL ADConnector is turned on and has internet
connectivity. Then ping it again.
•
If the SonicWALL Directory Services Connector is not responding or is alive but
has a very long ping time (greater than 50 milliseconds), you should add a static
route from the SonicWALL CSM to the SonicWALL ADConnector.
•
If the SonicWALL Directory Services Connector is alive
with a fast ping time,
your connectivity from the SonicWALL CSM to the SonicWALL ADConnector is
good. Verify that the service is running and that the user you configured it with
has sufficient privileges to communicate with the Active Directory domain
controller.
Summary of Contents for Content Security Manager 2200
Page 43: ...Page 42 Notes...
