SECTION 2
60 inch GLASS WASHING MACHINE
Model TTW 606, 6 Brush Washer
Capacity -
The Washer accepts single strength to ½
inch thick glass, from 11 inches wide 14 inches long
to full width sheets. The line speed is variable from 0
to 35 feet per minute.
Brushes -
The spiral-wound brushes in “dense-fill”
construction are 6 inches in diameter, mounted on
stainless steel cores and individually adjusted for
proper height. Brushes are V-belt driven by a
common motor and can be individually adjusted, to
compensate for wear, by raising the tilt-top.
Drying System -
In the 6 brush Washer, a 15 HP
blower with an air intake filter is connected to four
air knives; two knives above the glass and two knives
underneath the glass. An insulated enclosure covers
the drying system and reduces the noise to acceptable
levels.
Rollers -
The feed and pinch rollers are 2½ inches in
diameter, made with stainless steel journals and
heavy steel tubing with a precision ground Nitrile
covering. The rollers are driven by a ¼ HP DC gear
motor using chain and sprockets.
Bearings -
The brushes are supported on ball
bearings. The upper pinch rollers are mounted on
pivoting brackets. The rotating action of the pivots
smoothes the movement of the thicker pieces of glass
through the machine.
Frame -
The frame is a one piece steel weldment
with machined upper sidebars. The infeed and
unloading conveyors are two feet long each. All
sections that become wet through normal operation
are either plated, coated or made from a corrosion
resistant material. Plumbing, tanks, detergent/rinse
cabins, pans and covers are constructed from
stainless steel.
Electrical -
The control panel is mounted on the
machine with conduit wiring. All electrical circuitry
is built to NEMA 12 specifications to meet OSHA
requirements. Every panel is UL approved.
The power requirements are 3 phase, 60 cycle,
208/230/460 volts. The electrical panel name plate
specifies the full load amperage.
Water -
A water/detergent solution is applied
through spray pipes; one on either side of the glass
per brush. Threaded plugs on the spray pipe ends
allow for easy cleaning. The water usage is about 7½
gallons per minute without the Aqua-Miser rinse;
about 2½ gallons per minute with. There will be
minimal (zero) consumption (due to drag out and
evaporation) when used with the Aqua-Miser ready
option.
Options -
The recirculating detergent system, miser
rinse system, Aqua-Miser ready (zero water), auto
glass thickness adjustments, power brush adjustment
and hydraulic power tilt-top are all options. A wetted
parts package constructed out of stainless steel for
use with a de-ionized water system is also an option.
MODEL
NUMBER
STYLE BRUSH MOTORS
WIDTH LENGTH
HEIGHT
BLOWER
HP
HEATER
TTW 606
60 inch
one 3 HP
one
⅛
HP
6 feet
9 inches
10 feet
3 inches
3 feet
8 inches
15
6 brush
15
kW
GLASS WASHING MACHINES
5
