www.tecnoshades.com
Step 1. Press the PROG button for four seconds until the
electric motor cycles.
Step 2. Press the STOP button for two seconds until the
electric motor cycles.
Step 3. Press the PROG button for two seconds until the
electric motor cycles.
Step 1. Disconnect the power supply for 2 seconds.
Step 2. Connect the power supply for 5 to 15 seconds.
Step 3. Disconnect the power supply for 2 seconds.
Step 4. Connect the power supply, the motor will cycle.
Step 5. Press the PROG button on the new remote for 0.5
seconds, until the electric motor cycles; The new remote has
been programmed and all registered remotes will be
deleted.
Step 1. Press the PROG button for four seconds, until the
motor cycles.
Step 2. Press the UP and DOWN buttons at the same time
for 2 seconds, until the motor cycles.
Step 3. Press the PROG button for 2 seconds, until the
electric motor cycles.
1.
2.
3.
1.
2.
3.
5.
1.
2.
3.
4.
CHANGING THE DIRECTION OF ROTATION
REPLACE THE REMOTE CONTROL
RESET ENGINE
Note:
The operation will delete all registered remote controls; however the
motor will retain the stroke limits.
Notes:
Any other operation will interrupt the reset process.
The procedure will remove all registered remote controls and stroke limits, the
engine will return to factory condition.
After the electric motor is reset, you have two minutes to register a remote (see step
1, "Initial Programming").
Cycle
4 seg.
2 seg.
2 seg.
Cycle
Cycle
2 seg.
2 seg.
2 seg.
5 seg.
a 15 seg.
Cycle
Cycle
0.5 seg.
2 seg.
Ciclo
4 seg.
2 seg.
