www.tecnoshades.com
SET THE LIMITS OF STROKE
Step 1. Press the UP and STOP button until the electric motor
cycles.
Step 2. Using the UP or DOWN buttons move the motor
where you want to set the upper limit.
Step 3. Press the PROG button for 2 seconds, until the electric
motor cycles.
MODO USER MODE
ADD A REMOTE
Step 1. Press the programming button with a thin tool on the
already registered remote/channel for four seconds, until the
motor cycles.
Step 2. Select the new remote/channel you wish to add and
press its PROG button for two seconds, until the motor cycles.
Note:
the procedure must be performed after confirming the direction of
rotation. The order of setting limits does not matter.
Before setting stroke limits, the electric motor runs in stepping mode.
Note:
The procedures must be performed within 2 minutes, otherwise the electric
motor will cycle and return to the previous state.
Programming can be canceled by pressing “UP+STOP+DOWN” for 0.5
seconds before confirming by pressing the PROG button for 2 seconds.
Note:
You can add up to 12 remote controls to one electric motor.
1.
2.
3.
1.
2.
3.
2.
1.
Cycle
Cycle
o
Set upper limit
Step 1. Press the DOWN and STOP button until the electric
motor cycles.
Step 2. Using the UP or DOWN buttons move the motor
where you want to set the lower limit.
Step 3. Press the PROG button for 2 seconds, until the electric
motor cycles.
Set lower limit
Cycle
Cycle
o
Cycle
Cycle
4 seg.
2 seg.
