PROGRAMMING
www.tecnoshades.com
CHANGING THE DIRECTION OF ROTATION
The following programming instructions must be carried out
step by step.
If the power supply was suspended or timed out before the
third step, you must start from the first step after restoring the
power supply.
Feedback = cycle: It is a short movement of the electric motor
up and down.
If the direction of rotation is correct
Step 1. Use a thin tool to press the PROG button for 2
seconds, until the electric motor cycle.
If the direction of rotation is incorrect
Step 1. Press the STOP button for 2 seconds, until the electric
motor cycles, the direction of rotation was reversed.
Step 2. Press the PROG button for 2 seconds, until the electric
motor cycles.
Register the first remote control on a tubular motor
Step 1. Energize the motor.
Step 2. Press the UP, DOWN buttons on the remote at the
same time.
Step 3. A feedback motion will confirm that the remote has
been temporarily enrolled
in the memory of the tubular motor.
Note:
The procedure must be performed within 2 minutes after turning
on the power supply or resetting the electric motor.
Notes:
The procedure must be performed within 2 minutes after registering the
first remote control.
The direction of rotation can be reversed over and over again by pressing the
STOP button for 2 seconds before confirming the PROG button for 2 seconds.
The direction of rotation must be confirmed by pressing the PROG button for 2
seconds, and then continue with the programming procedure.
Cycle
1.
1.
1.
2.
3.
2.
Cycle
2 seg.
Cycle
2 seg.
