Copyright © 2010 Somfy SAS. All rights reserved.
Sunea screen io
7
EN
Modification for vertical awnings with upper stop only
7.3.2.
For awnings with upper stop (load bar stopped under the head rail), the upper end limit is adjusted
Deleting the favourite position (my)
7.1.2.
1) Press the «my» button: the awning will start to move, and stop in the favourite position (my).
2) Press the «my» button again until the awning moves: the favourite position (my) has been deleted.
Adding/Deleting Somfy io control points and io sensors
7.2.
Refer to the corresponding guide.
Modifying end limits
7.3.
Modification of end limits depends on the type of awning.
Modification for vertical awnings without upper stop and lateral arm-mounted
7.3.1.
awnings
For vertical awnings without upper stop or lateral arm-mounted awnings without head rail, both
Favourite position (my)
7.1.
Programming or modifying the favourite position (my)
7.1.1.
The procedure to follow for programming or modifying the favourite position (my) is identical.
ADDITIONAL SETTINGS
7.
1
or
3
2
4
1
2
3
or
4
1
2
my
or
1
2
4
3
or
1) Put the awning in the desired favourite position (my).
2) Press the «my» button until the awning moves: the
desired favourite position (my) has been programmed.
end limits may be modified.
Readjusting the upper end limit
1) Position the awning at the upper end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning’s top position using the Up or Down
buttons.
4) Press the «my» button until the awning moves: the new
upper end limit has been programmed.
Readjusting the lower end limit
1) Position the awning at the lower end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning’s bottom position using the Up or
Down buttons.
4) Press the «my» button until the awning moves: the new
lower end limit has been programmed.
automatically, while the lower end limit can be modified.
Readjusting the lower end limit
1) Position the awning at the lower end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning’s bottom position using the Up or
Down buttons.
4) Press the «my» button until the awning moves: the new
lower end limit has been programmed.
Summary of Contents for Sunea io
Page 43: ......