Copyright © 2010 Somfy SAS. All rights reserved.
Sunea screen io
6
EN
OPERATION
6.
Using a pre-programmed Somfy io local control
5.5.1.
point
Briefly press the PROG button on this control point: the
-
awning will make a brief movement; the control point has
been programmed.
After a single power cut
5.5.2.
1) Press the Up and Down buttons simultaneously on the
new control point until the awning moves.
2) Briefly press the PROG button on this control point: the
awning will make a brief movement; the control point has
been programmed.
Checking the settings
5.6.
Standard operation
6.1.
Favourite position (my)
6.1.1.
Definition
Besides the upper and lower positions, an intermediate position known as the «favourite position (my)»
may be programmed in the motor.
To program, modify or delete the favourite position (my), see the section «Additional settings».
To use the favourite position (my):
PROG
1
2
Programming the first Somfy io local control point
5.5.
PROG
Check the settings of the upper and lower end limits using the Somfy io local control point.
-
my
my
30 s
Up / Down buttons
6.1.3.
Briefly press the Up or Down button to raise or lower the awning fully.
Operating with a Somfy io sensor
6.2.
Operating with a Somfy io sun sensor (such as Sunis WireFree™ io)
6.2.1.
Refer to the corresponding guide.
Operating with a Somfy io wind sensor (such as Eolis WireFree™ io)
6.2.2.
Refer to the Somfy io wind sensor guide for details of its operation.
Reaction of the awning to the wind rising
When the wind rises, the awning will start to move up to
the upper end limit. It is impossible to prevent the awning
from closing, or to lower it while the wind is still blowing.
Reaction of the awning to the wind dropping
When the wind has dropped, a manual down order may
be issued via the io control point after 30 seconds. However,
all automated systems will remain locked for 11 mins.
Feedback
6.2.3.
After each order, the Sunea io sends a message. This
Briefly press the «my» button: the awning will start to
-
move, and stop in the favourite position (my).
STOP function
6.1.2.
The awning is moving.
Briefly press the «my» button: the awning will stop
-
automatically.
response is processed by the io two-way control points.
Summary of Contents for Sunea io
Page 43: ......
