11
EN
- SLIDYMOOVE 300 installation and operating guide - SOMFY
E
N
Installation
1
EN
11
1.3
Case of specific installation:
gate with lower brace
Check that:
•
the motor is level.
•
the gate runs correctly,
•
the pinion is correctly driven.
•
the 2 mm clearance between the rack and pinion
does not vary significantly .
If these conditions are not satisfied, adjust the
height of the rack.
Once all these checks have been completed,
tighten the nuts to fasten the motor
permanently.
1.4 Checking the installation of the motor
17
T25
The metal plate supplied must be installed under the motor. The plate must be in direct contact with the
motor to ensure it is sealed and protected against large debris, insects, etc.
40 mm
•
Place the metal plate
40 mm from the gate
and parallel to it.
•
Mark the 4 anchoring
points for the metal
plate on the ground.
•
Remove the metal
plate.
•
Drill the 4 holes in
the concrete using
a concrete drill bit,
diameter 12, to a
depth corresponding
to the plugs.
•
Insert the 4 plugs
into the concrete
and screw the 4
pins using the torx
screwdriver.
•
Insert a nut and
washer on each pin .
•
Position the metal
plate level.
•
Remove the motor
cover.
•
Position the motor on
the pins, feeding the
cables through the
locations provided for
this purpose.
•
Tighten the washers
and nuts.
1
2
3
4
The rack provided in the pack is not suitable for a gate with a bottom brace.
A low-fastening rack (ref. 9011089) must be used. Please contact Somfy.
