10
EN
- SLIDYMOOVE 300 installation and operating guide - SOMFY
E
N
EN
1
Installation
10
"
Fastening the rack and pinion
•
The rack and pinion must be
fastened to the gate brace.
•
Use screws suitable to the material
of your gate (see page 8).
•
Never lubricate the motor rack or
pinion.
1
Rack fastening mark
2
•
Open the gate completely.
•
Position the pencil in the notches provided for
this purpose then slide the gate to mark the
anchoring point.
•
Position the rack by aligning the top of the
oblongs holes with the mark.
•
Fasten the first element of the rack at the top of
the oblong holes, beginning at the leF-hand side
of the gate.
•
Install and fasten the other items in the same
way, interlocking them with the others.
If required to anchor the rack, you can raise the motor by a maximum of 30 mm.
•
Remove the motor and the mounting plate from the pins.
•
Insert a nut and washer on each pin and position at the desired height (max. 30 mm from the ground).
•
Replace the plate and motor on the pins.
•
Check that the plate and motor are level.
•
Fastening the rack at the top
of the oblong holes ensures
the 2 mm clearance necessary
between the rack and pinion.
•
If the fastening points are too
close to the edge of the brace:
fasten the rack at the centre of
the oblong holes.