9
EN
- SLIDYMOOVE 300 installation and operating guide - SOMFY
E
N
1.1 Unlock the motor
1.2 Case of standard installation
!
Fastening the motor
to the ground
The metal plate supplied must be installed under the motor. The plate must be in direct contact with the
motor to ensure it is sealed and protected against large debris, insects, etc.
30 mm
•
Place the metal plate
30 mm from the gate
and parallel to it.
•
Mark the 4 anchoring
points for the metal
plate on the ground.
•
Remove the metal
plate.
•
Drill the 4 holes in
the concrete using
a concrete drill bit,
diameter 12, to a
depth corresponding
to the plugs.
•
Insert the 4 plugs
into the concrete
and screw the 4
pins using the torx
screwdriver.
•
Position the metal
plate level.
•
Remove the motor
cover.
•
Position the motor on
the pins, feeding the
cables through the
locations provided for
this purpose.
•
Tighten the washers
and nuts.
1
2
3
4
•
Remove the motor cover.
•
Press on the lever (on the right, grooved
section).
•
Pull the lever.
The pinion is freed.
The motor is unlocked.
Once installation is complete, there will be 4 nuts and 4 washers unused.
17
T25
12
INSTALLATION
1
FR