![background image](http://html1.mh-extra.com/html/somfy/lighting-receiver/lighting-receiver_installers-manual_1318155007.webp)
7
© 2015 Somfy SAS. All rights reserved. 01/2015
EN
5. WIRING
- Switch the power supply off.
- Connect the io On/Off Lighting receiver as
shown in the table below and the illustration :
- Mains 230V/50 Hz (A)
- Power supply (AC/DC) (B)
- Control voltage (1-10V) (C)
A
Blue
Neutral
B
Blue
Neutral
C
Blue
Dim +
Brown
Live
Brown
Live
Brown
Dim -
Green/Yellow
Earth
Green/Yellow
Earth
Cable length
50 cm
Cable length
30 cm
Cable length
50 cm
6. SET-UP
This guide describes set-up using only a Situo io type Somfy io local control point. To perform
set-up using a different io control point, refer to the corresponding instructions.
Light on
Light off
Feedback
VARIATIO
N io
Ref : 5107825 A
Made in Roman
ia
Somfy 74300 –
France
LIGHTIN
G RECEIV
ER
Dim +
(Blue)
Dim –
(Brown)
1 – 10 V
- 20T + 50
IP55
IN
230V ~ 50
Hz
OUT
500W
50 cm
30 cm
230V ~
50Hz
50 cm
+
-
A
C
B
«my» light
position
Only one blank receiver must be powered at a time.
- Switch on the power supply.
- Press the Up/Down buttons on the Somfy io local control
point simultaneously and follow procedure “a” or “b” de-
pending on how the light reacts:
a) The light comes on then goes out.
{~ [ Ê'× ^L [ &
control point: the light comes on then goes out again to
indicate that the Somfy io local control point has been
programmed into the io On/Off Lighting Receiver.
Go to section 7 “Use”.
b) The light does not come on.
Press the Up button.
c) If the light comes on:
The Somfy io control point has been programmed.
Go to section 7 “Use”.
d) If the light does not come on:
- Check the status of the light/LED/converter and try
again.
R × & ÈÉ ØÊ [ LÙ
Programming a Somfy io local control point
a
b
ON
c
d