SOMFY HOME MOTION Chronis io, User Manual

Page: 15 / 116

Copyright © 2013 Somfy SAS. All rights reserved.
Chronis io
13
EN
6) The screen displays "
SAVE
:
YES
". Click OK to terminate and save the settings for the current menu.
7) The Chronis io returns to the previous step.
Choose "
SAVE : NO
" and press OK to restart the procedure for setting the date and time parameters
from the beginning.
8) Press
‹
or
›
until "
EXIT SET
" is displayed (after "
DEC
") and press OK.
9) "
SET
" flashes: press
‹
or
›
until "
EXIT
" is displayed and press OK.
Questions about the Chronis io?
Observations Possible causes Solutions
The selected products do not
react at all when a button on
the Chronis io is pressed.
The batteries are low. Replace the batteries.
The remote control transmitter is
not programmed.
See section " Adding or deleting a Chronis io
at an end-product ".
External radio equipment is
interfering with the radio reception.
Turn off any radio appliances nearby.
The motor(s) or receiver(s) are in
thermal cut-out mode.
Wait for the motor to cool down, then press
the desired button again.
An end-product stops during
activation.
The end-product has encountered
an obstacle.
Remove the obstacle and try again.
Another control point is sending an
order to the motor or receiver.
Wait until activation of the end-product has
finished, then try again.
The order is shifted in relation
to the programmed time.
The Chronis io is in simulated
presence mode.
Select automatic mode using the cursor.
One or more end-products
systematically do not react
to a programmed automatic
order.
A signal from another automatic
device in your home is causing
interference.
Increase the number of frame repetitions.
See section " Initial configuration ".
Change the programmed time for the
automatic order.
"
ERROR
"
is displayed. The
Chronis io only works in
manual mode .
Defect in automatic mode
and simulated presence mode
.
Contact an installer.
8. TIPS ANd RECoMMENdATIoNS
9. TECHNICAL dATA
Radio frequency: 868.95 MHz, io-homecontrol
®
Radio range: 20 m through 2 concrete walls
Protection rating: IP 20
Safety level: Category III
Operating temperature: 0 °C to + 60 °C (+ 32 °F to + 140 °F)
Dimensions (w x h x d): 120 x 80 x 21 mm
Power supply: 2 type AAA (LR03) 1.5 V alkaline batteries