animeo
KNX RTS RECEIVER . REF. 5066737C -
8/16
[3]
Delete a sender
Press Reset/Prog button at the trained sender
1
or
on the Motor Controller
2
for 2 seconds.
H
The trained transmitter and the transmitter to be
deleted do not have to belong to the same channel.
A random LED shines. Press Prog button of the sender
to be deleted. LEDs confirm successful learning in.
H
1 remote remains trained and cannot be deleted.
[4]
Deleting all senders of a channel
Press Reset/Prog button on Motor Controller for ap-
prox. 2 seconds. Green LED lights up.
Choose channel by pressing shortly the Reset/Prog
button. Repeat until such time as the required LED
shines.
Keep Reset/Prog button pressed. After 5 seconds
all LEDs shine and confirm successful deleting of all
senders of a channel.
Release Reset/Prog button. LED confirm with a short
blinking the deleting of the required channel.
[5]
Reset into delivery status/Deleting
all senders of an animeo KNX RTS
Receiver
Press Reset/Prog button on Motor Controller for 2
seconds. Green LED lights up briefly. After 5 seconds
all LEDs shine briefly. After a following 5 seconds all
LEDs shine again briefly. Release the Reset/Prog but-
ton. Successful deleting of all senders and channels
is confirmed with a short LED blinking. RTS radio
module is again on delivery status.
H
If the Reset/Prog button of the Motor Controller is
kept pressed for longer than 14 seconds, the Motor
Controller will be also reset!
A
MOUNTING
[1]
Switch off voltage supply.
[2]
Remove the cover of the animeo Motor Controller.
[3]
Place the animeo KNX RTS Receiver.
[4]
Switch on voltage supply.
[5]
The radio module is installed successfully. The LED’s
shine according to picture.
B
CONFIGURATION
Notes:
• Several animeo KNX RTS Receivers should not be
programmed at the same time.
• The animeo KNX RTS Receiver has 5 channels.
Max. 4 radio remote controls can be learned in on
each channel.
• The learning readiness ends automatically after 60
seconds if no input takes place.
[1]
Train the first sender
Press Reset/Prog button on Motor Controller for
approx. 2 seconds. Green LED lights up. Choose
channel with Reset/Prog button. Press shortly Prog
button of the remote control you want to learn in.
LEDs confirm successful learning in.
[2]
Train further sender
Press Reset/Prog button at the trained sender
1
or at the Motor Controller
2
for 2 seconds. Green
LED lights up. The desired channel can be chosen
with both the Up/Down buttons of the sender or
the Reset/Prog button of the Motor Controller. Press
repeatedly until the desired LED shines.
Press shortly Prog button of the remote control you
want to learn in. LEDs confirm successful learning in.
EN
Somfy hereby declares that the radio equipment covered by these instructions is in compliance with the requirements of Radio Directive
2014/53/EU and the other essential requirements of the applicable European Directives.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
