SOMFY 1115202, Installation Manual

Page: 18 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
16
EN
6.1.4 Using the emergency crank
Never use the emergency crank if a RTS control point
is not programmed in the motor.
Do not lower the awning below the arm breakage point
with the crank.
Check that the mains power supply is off. -
Hook the Somfy emergency crank into the eye outlet. -
Turn the crank to raise or lower the awning. -
6.2 Operation with an RTS sensor
6.2.1 RTS sun sensor
Refer to the corresponding guide.
6.2.2 RTS wind sensor
Refer to the RTS wind sensor guide for details of its operation.
Awning’s behaviour when the wind rising
when the wind rising, the awning moves to the upper
end limit.
However, It is impossible to prevent awning from
being raised and lowered when the wind is blowing at
speeds above the threshold set.
Awning’s behaviour when the wind dropping
when the wind dropping, a manual lowering command
can be sent by the RTS control point after 30 seconds
However, all automated systems will still remain
locked for 12 min.
6.3 Operation after a single power outage
The Sunea CSI RTS is fitted with an electronic system enabling it to withstand power outages of less
than 2 mins. For longer power outages, the motor switches to a mode for resetting the end limit.
To return to standard operating mode, carry out one of the following 3 operations.
Using the Up button
Briefly press the Up button to raise the awning completely and return to the standard operating
mode
Using the Down button
Briefly pressing the Down button to lower the awning for 1.5 seconds and raise until it stops when
the torque is detected, then lower again to the lower end limit and return to the standard operating
mode.
Wind rising
When the wind speed exceeds the threshold set on the RTS wind sensor a raising command is sent
to the motor.
The awning is raised to the upper end limit and returns to the standard operating mode.
The sun function is inactive until a raising, lowering or wind rising operation has reset the motor
to the standard operating mode.
7. Additional settings
7.1 Favourite position (my)
7.1.1 Setting or modifying the favourite position (my)
The procedure for setting or modifying the favourite
position (my) is the same.
Set the awning into the desired favourite position (my). 1)
Press the “my” button until the awning makes a 2)
movement: The favourite position (my) has been
programmed.
OFF
30 sec
1 2
my
or