SOMFY 1115202, Installation Manual

Page: 16 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
14
EN
5.3 Cheking the direction rotation of the motor
Set direction rotation of the motor.
Press the Up button: 1)
If the awning is raised, the direction of rotation is a)
correct: go to the stage entitled
“ Setting the end limits ” .
If the awning is lowered, the direction of rotation is b)
incorrect: Press the “my” button until the awning makes a
movement: The direction of rotation has been modified.
Press the Up button to check the direction of rotation. 2)
5.4 Setting the end limits
The end limits are set differently depending on type of awning.
5.4.1 Settings for cassette awnings
For cassette awnings, the upper end limit is set automatically, while the lower end limit must be set.
Setting the lower end limit
Do not use the “my” and Down buttons at the same time to
reach the lower end limit.
Set the awning to the lower end limit. 1)
Press and hold the Down button for > 2 seconds to
lower the awning in a single movement.
Stop the awning in the desired position. 2)
If necessary, adjust the position of the awning using the 3)
Up and Down buttons..
Press the “my” and Up buttons simultaneously: The
4)
awning is raised in one continuous movement even after
the “my” and Up buttons have been released.
At the halfway point, briefly press the “my” button to stop
5)
the awning.
Press the “my” button again until the awning makes
6)
a movement (1.5 seconds downwards then upwards
until the cassette closes): The end limits have been
programmed.
Wait for the awning to stop completely before going to the chapter “Programming the first RTS control
point.
5.4.2 Settings for non-cassette awnings
For non-cassette awnings, the upper and lower end limits
must be set.
Setting the upper end limit
Set the awning to the upper end limit. 1)
Press and hold the Up button for >2 seconds to raise
the awning in one continuous movement.
Stop the awning in the desired position. 2)
If necessary, adjust the position of the awning using the 3)
Up and Down buttons.
Press the “my” and Down buttons simultaneously : the
4)
awning is lowered in one continuous movement even
after the “my” and Down buttons have been released.
At the halfway point, briefly press the “my” button to stop
5)
the awning and go to the following step.
a
b
Setting the end limits
1
2
1
3
5
2
4
6
1
3
5
2
4
Go to the following
step