SOMFY 1115202, Installation Manual

Page: 21 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
19
EN
8. Tips and recommendations
8.1 Questions about the Sunea CSI RTS ?
Observations Possible causes Solutions
The awning does not
operate. The wiring is incorrect. Check the wiring and modify it if
necessary.
The motor is hot. Wait until the motor cools down.
An incorrect cable has been
used. Check the cable and ensure it has 3
leads.
The RTS control point battery is
weak. Check whether the battery is weak and
replace it if necessary.
The RTS control point is not
compatible. Check for compatibility and replace the
RTS control point if necessary.
The RTS control point used has
not been programmed into the
motor. Use a programmed RTS control point or
program this RTS control point.
There is radio interference. Turn off all radio equipment nearby.
The awning stops too
soon. The crown is incorrectly
positioned. Fit the crown correctly.
The end limits have been
incorrectly set. Readjust the end limits.
The awning is stuck
in the lowest position
and can only be
lowered. Bad repositioning of the end
limits after cutting the power
supply and/or using the
emergency crank. Using the emergency crank, up the
awning in its median position and give
an up order using the RTS control point.
8.2 Replacing a lost or broken RTS control point
Refer to the corresponding guide.
8.3 Restoring the original configuration
This reset deletes all the RTS control points, all the sensors, all the end limit settings and resets
the motor’s direction of rotation and favourite position (my). However, the advanced functions
setting (“Back impulse”, “Back release”, “Closing force”) are kept.
Only switch off the current for the motor to be reset.
Do not use the Inis RT/Inis RTS control point for resetting.
1) Set the awning to the halfway position (if possible).
Cut the power supply off for 2 seconds. 2)
Switch the power supply back on for 5 to 15 seconds. 3)
Cut the power supply off for 2 seconds. 4)
Switch the power supply back on: The awning moves 5)
for several seconds.
if the awning is in the upper or lower end limit position
it will make a brief movement.
Press and hold the PROG buttons: the awning will 6)
make a first movement, and repeat it a few moments
later.
The motor is configured with the factory settings.
Repeat the procedures in the chapter “
- Commissioning ”.
2 secs
2 secs
15 secs
5 secs
PROG.
1
6
5
3
2
4
OFF
OFF
ON
ON
my