SOMFY 1115202, Installation Manual

Page: 19 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
17
EN
7.1.2 Deleting the favourite position (my)
Press the “my” button: The awning moving: and stops in 1)
the favourite position (my).
Press the “my” button again until the awning makes a
2)
movement: The favourite position (my) has been deleted.
7.2 Adding/Deleting RTS control points and RTS sensors
Refer to the corresponding guide.
7.3 Modifying the end limits
The end limits are modified differently depending on type of awnings
7.3.1 Modification for cassette awnings
For cassette awnings, the upper end limit is adjusted
automatically while the lower end limit can be modified.
Reajusting the lower end limit
Set the awning to the set lower end limit. 1)
Press the Up and Down buttons simultaneously until 2)
the awning makes a movement : the motor is in setting
mode.
Adjust the lower position of the awning using the Up or
3)
Down buttons.
Press the “my” button until the awning makes a
4)
movement : the new lower end limit position has been programmed.
7.3.2 Modification for non-cassette awnings
For non-cassette awnings, the upper and lower end limits
can be modified.
Reajusting the upper end limit
Set the awning to the set upper end limit. 1)
Press the Up and Down buttons simultaneously until 2)
the awning makes a movement : the motor is in setting
mode.
Adjust the upper position of the awning using the Up or
3)
Down buttons.
Press the “my” button until the awning makes a
4)
movement : the new upper end limit has been programmed.
Reajusting the lower end limit
Set the awning to the set lower end limit. 1)
Press the Up and Down buttons simultaneously until 2)
the awning makes a movement : the motor is in setting
mode.
Adjust the lower position of the awning using the Up or
3)
Down buttons.
Press the “my” button until the awning makes a
4)
movement : the new lower end limit has been
programmed.
7.4 Modifying the direction of rotation
To modify the direction of rotation after setting the end limits, the motor’s factory settings must be
restored. See the section entitled
“Restoring the factory settings” .
1 2
my
1 2
4 3
or
1
or
3
2
4
1
3
2
4