Platné od: 7.3.2017
Somati system s.r.o., Jihlavská 510/2c, 664 41 Troubsko
IČ: 29260159, DIČ: CZ29260159
tel: +420 547 427 011, www.somati-system.cz
3
Operating temperature of the Slidetronic II switchboard is from +10°C to +35°C. If the
ambient temperature is lower than +10 °C or higher than+35 °C, the switchboard cannot
be used! Temperatures above +25 °C and under +15 °C, cause shortening of battery life.
Exceptionally, the Slidetronic II switchboard can be operated at lower temperatures,
maximally to −5 °C, on condition that the input power is permanently connected to
provide minimal warming of the control circuits.
4.
FUNCTIONS OF THE CONTROL PANEL SLIDETRONIC II
LED switch plate:
LED (green LED) = network (voltage 230 V)
-
On = network is connected
-
Flashing = no network (if the battery is connected)
-
Off = stopped activity (no voltage 230 V and no battery)
LED (red LED) = movement of gate
-
On = gate is not moving
-
Flashing = gate is closing
LED (yellow LED) = battery status
-
On = charged over 3,9 V
-
Flashing = battery is charging
-
Off = discharged or no battery
LED (red LED) error (!)
-
1
flash = alarm of detectors
-
2 flash = alarm of EPS
If the two alarms are activated at the same time, they are displayed sequentially i.e. one
flash – pause – two flashes.
Note: If the battery is in the device and there is a power failure, the standby mode is
activated. Voltage of the battery falls below 3.3 V, the unit goes into standby mode, turns
off all relays, disconnects the detectors, reduces its own consumption and repeatedly after
35 s., the LEDs gradually flash on the swich plate from left to right.
START/STOP
RESET
START/STOP
Figure 1: Control Panel
