CSW-M85 User’s Manual Ver. 1.6
Sollae Systems Co., Ltd.
- 25 -
http://www.sollae.co.kr
3.2
AT command
In the AT command mode, you can change some parameters through the serial port.
Checklists
Make sure the connection between your PC and CSW-M85 using RS232 cross cable
(In the case of using EVB). To use this mode, CSW-M85 has to be set to [AT
command] mode of the [Communication mode]. This can be configured by
ezManager.
Although you don’t connect CSW-M85 to evaluation board but MCU, parameters
of serial communication are needed to be set to the same values with your MCU.
Figure 3-5 setting the communication mode to the AT command
Procedures
Figure 3-6 configuration procedures with AT command
Table 3-1 parameters which are available on AT command
Division
Available parameters
IP Address related items
Local IP Address, DHCP, PPPoE, Subnet Mask, Gateway IP
Address, DNS IP Address and etc.
TCP connection related items
Local Port, Peer Address (IP Address or Host name), Peer
Port and etc.
WLAN related items
Topology, SSID, WEP, WPA-PSK, WPA2-PSK and etc.
Option
ESC code sending option, timeout and etc.
Including the above items, all parameters can be set by ezManager.
