3.1.2 Output level
The unit has an output level control, acting on "Output to Console".
This control allows to compensate the level for a communication
that reaches very attenuated.
HL203-VQ model has a needle type VU meter, which shows the
console output level. It is important to maintain the appropriate level
to excite the VQR stage correctly. The optimum working level is 0
VU, with the needle in the red zone only during short peaks.
When operates with
Bluetooth
, rememmber to check that the
volume
of cell phone be at maximum.
3.2
Using Bluetooth
(only HL203-VQ)
The Bluetooth stage start up by pressing
and holding down BLUET until the LED
glows green (2 sec. approx.). After
releasing the button the green led flashes
slowly. The cell phone must be switched
on and less than 30 feet away.
Previously, HL203 should be linked to cell phone. This is done only
once, as explained in "2.3.2 - Bluetooth connection.
To avoid interference from other systems is desirable that the distance
between the cell and the HL203 is always minimum.
3.2.1 Receive a calling
While the cell phone is in Bluetooth mode, you can answer an
incoming call from the hybrid with a short touch of the button BLUET
(Bluetooth must be turned on, green light flashing slowly), or can
answer directly from the cell phone, as explained below.
SOLIDYNE
Telephonic Hybrids
Page 23
