2.4.2
Hybrid send & return in consoles Solidyne 2300 series
The 2300 series consoles with master Solidyne 2307 provide
connection to send and return hybrid; through a stereo jack ¼" located
on the rear panel. In this way the external hybrid is also managed from
the hybrid's fader, avoiding having to use input channels for
connection of the hybrid.
You can ask Solidyne on purchase of hybrid, the cable to connect to
2300 console. Or you can assemble yourself. The cable will have a
stereo plug (TRS 1/4”) that connects two shielded cables (shield and
one conductor). One cable connects the tip to a mono plug (TS 1/4")
and the other one connects the ring to a female XLR. The following
table shows the connection.
“External hybrid”
connector in consoles
2300
(TRS 1/4”)
HL-202 / 203
Send to phone line
(plug mono 1/4”)
Balanced output
(female XLR)
Tip
tip
-
Ring
-
pin 2
Sleeve (GND)
sleeve
pin 1 (pin 3 n/c)
I/O connection to an external hybrid in Solidyne 2300 consoles. Stereo plug brings two
cables (Y-cable) (shield and conductor; Belden type). See Figure 5 in page 19.
For Solidyne consoles of other models, and for consoles of others
marks, check the user's manual for send and return conections to
external hybrid.
If the console do not have conection Si la consola no tiene conexión
para envío/retorno de híbrido externo, el HL-202 deberá conectarse a
un canal de línea, como se explica más adelante.
In the console 2300, external hybrid signal is sent to the hybrid
control at Master module. See the manual for the operation console
with external hybrid.
Remember that the three-line hybrid built on consoles Solidyne 2300,
is kept working when you connect an external hybrid, able to work in
conference with internal and external lines (console with serial #
ending in "C").
Page 14
Telephonic Hybrids
SOLIDYNE
