Solid State Logic AWS 900+ SE, Owner'S Manual

Page: 21 / 171

Removing the trim
If it is necessary to remove the trim panels – to adjoin existing furniture – then please refer to the following
information and the illustration shown on the facing page.
Note that it is not necessary to remove any of the audio modules to gain access to the trim fixing screws.
Front Buffer
The front buffer is secured by nine pan-head screws – five in the front beam and two in each end trim. These are
all visible from beneath the buffer.
End Trim
Each of the end trims is secured by four countersunk Posi-head screws through the profile (one is located in the
kneepanel area, two more are found either side of the main beam and the fourth is located on the bottom corner
of the outside profile), as well as two pan-head screws through the front buffer (visible from beneath the buffer).
Top Trim
The top trim is clipped over the front of the meter panels and secured onto the back panels by four M3 screws.
AWS 900+ SE Owner’s Manual
3-5
Installation