Customer service: 1-888-707-1880
Dyaco Canada Inc 2021
Email: [email protected]
11
SFT160 STEP FOUR
Repeat this step for both sides of the machine.
Follow the diagram with the Cable Assembly (No. 33) through the framework as shown. Pay
special attention to make sure the cable end with the bolt is connected at the "Start," and
the cable end with the loop is positioned at the "Finish," as shown in the diagram.
At the end of "Finish," attach cable sheath (No.33-4), rubber sleeve (No.33-6) onto the
cable (No.33-3), insert cable connector (No.33-2) into the cable sheath (No.33-4), securing
with bolt (No.33-1) and nut (No.33-5), attach the loop (No.33-7) onto the bolt (No.33-1).
Note: Wrench tighten bolts and nylon locknuts.
Please do not tighten the
pulley screws when
attaching the cable.
It is
possible to adjust the
tightness after finishing the
cable positioning with the
pulley screws. See example
below for the pulley screw
location. The pulley on the
Pulley Connecting Frame
(No. 13) can be removed to
allow for adjustments in
cable tension.
