Customer service: 1-888-707-1880
Dyaco Canada Inc 2021
Email: [email protected]
16
GENERAL MAINTENANCE
Links, Pull-Pins, Snap Hooks, Swivels, Weight Stack Pins:
Check all pieces for signs of visible wear or damage.
Check springs in snap hook and pull-pins for proper tension alignment.
If the spring sticks or has lost its rigidity, replace it immediately.
Decals
Inspect and familiarize yourself with any safety warnings or other user information posted on each decal
GENERAL MAINTENANCE
Nuts and Bolts
Inspect all nuts and bolts for any loosening and tightening if needed.
Go through a re-tightening sequence periodically to ensure that all hardware is tensioned proper
Belts and Cables
We use only high-quality belt, and mil-spec cables. Visually inspect the belt and cables for fraying,
cracking, peeling, or discoloration. While the machine is not in use, carefully run your fingers along the belt
or cable to feel for thinning or bulging areas. Replace belts and cables immediately at the first of damage or
wear.
Do not use equipment until belts or cables have been replaced.
Belt and Cable Tension
Referring to the Owner's Manual, when belt or cables are used, check all bolts attachments to be
sure they are properly attached. Check slack in cables and re-adjust cable tension if needed.
Seat Sleeves, Guide Rods
Wipe down adjusting tubes with a dust-free rag before applying lubricant.
Lubricate seat sleeves and Guide Rods with a Silicon or Teflon-based lubricant spray.
Linear Bearings
Referring to the Owner's Manual, carefully disassemble the bearing from its housing and place a
finger full of light grease (lithium, super lube, etc.) into the inside of the bearing. Using your finger,
press the grease into the ball-bearing and their tracks. Repeat until the ball-bearing tracks are full of
grease. Insert the shaft back into the bearing and wipe off excess grease.
