To prepare for the pipe runs, straighten the copper lines
by putting a foot on the end and carefully unroll the
tube and keep the line straight.
Carefully unroll the tubing through the roof boot into
the attic. If available, have a partner guide the tubing
to the tank being very carefull not to kink the line.
When working alone, it may be easier to unroll the
tube in the attic or first floor and send the tubing up
and through the roof boot from the attic.
Fully insulate all lines. Press about ½” of supplied high
temperature insulation into grommet hole to fully seal.
Covering the insulation with aluminum take and
painting is recommended. Be sure to overlap top over
bottom like the shingles for good water shedding.
SRCC requires a splash
plate under the pressure
relief valve shown here
glued to the shingles
under the outlet.
Summary of Contents for Fireball 20014
Page 2: ......
