Install the collector onto the rails with the mounting bracket tab UNDER the trim and BETWEEN the frame.
The small bend at the bottom of the trim makes inserting the mounting bracket easy. Be sure to press the
collector all the way down on the mounting rail and secure with two 1/4” color coded self tap screws evenly just
above the small bend in the trim.
Be sure to catch the tab with both screws!
Repeat the proceedure for the
center assembly and then tighten all lags to finish mounting the collector.
A NOTE ON MAKING TUBE
CONNECTIONS:
The tube connections top and bottom shown in top
view as 3 & 5, are made at the top and bottom of ONE
end of the collector. The connections can be at either
end of the collector simply by placing the collector
end left or right. When two or more collectors are
used they also connect at the same end (4).
Make sure you do not have a rafter
directly under the collector feed as the
feed hole is 1 and ½ inches below and in
from the end of the collector.
MOUNTING RAIL AND MOUNTING
BRACKET INSTALLATION STARTING
WITH SINGLE COLLECTOR:
A single collector is attached to the roof by three
"mounting rails and 6 mounting Ell brackets" (2).
Balance the Collector in
the Center and Carry to
Installation Area.
Summary of Contents for Fireball 20014
Page 2: ......
