Solana DRAFT 00, Owner'S Manual

Page: 78 / 127

HOW TO REMOVE AND REPLACE THE FRONT ACCESS PANEL
Your spa uses three panels that are attached to the frame. These panels are referred to as side panels and a front panel. The front panel is
located below the control panel. Behind the front panel, you’ll find all the electrical components. The front panel is held onto the frame
with six Phillip screws.
R
EMOVAL OF THE FRONT ACCESS PANEL
• Remove the six screw caps - Place a flat head screwdriver between the panel and the screw cap, then carefully rotate the
screwdriver to remove the screw cap.
• Remove the six Phillip screws. - Starting with the upper right corner of the front panel followed by the two below, then repeat on
the left side.
• Remove the front access panel - The top of the front panel is tucked behind the lip of the spa shell. Push down on the upper right
corner of the front panel (this will create a bow in the front panel) slide other hand behind the front access panel and pull front
panel away from the spa.
R
EPLACEMENT OF THE FRONT ACCESS PANEL
• Replace the front access panel - Position the left side of the front panel at a 45° angle tucking the upper left corner of the panel
under the spa shell while aligning the end of the panel with the scribe line. Lower panel, then continue tucking the top of the front
panel under the shell moving from left to right until the entire top of the front panel is tucked under the shell.
• Replace the six Phillip screws - Align the top left hole of the front access panel with the hole behind the panel, insert a Phillip
screw and rotate twice. Align the right top hole and insert a Phillip screw and rotate twice. Insert the other four Phillip screws into
the remaining holes, then tighten all six screws.
• Replace the six screw caps - Replace the screw caps by pushing the caps onto the screws using your thumb.
I
NSTALLATION
N
OTES
:
1. If you are an owner of a condominium, town home/patio home or are a member of a homeowner’s association, contact your
representatives regarding their requirements. If you have any questions regarding zoning requirements or building codes, contact
your local city government office.
2. IMPORTANT: The spa is designed for installation on a relatively flat and level surface. Installing the spa on an unlevel surface will
result in unlevel water and an aesthetically unbalanced spa, and may affect its performance. The spa may be shimmed according to
12
™