Loading New Firmware
23
P/N: 1006148-01
Configuring the Receiver
Loading New Firmware
Receiver board firmware is released as a compressed file that you download and decompress. This file contains
the following two files:
•
ramimage.ldr – the Receiver board RAM file
•
main.ldp – the Receiver board Flash file
To upload firmware files to the receiver:
1. Connect the receiver to a computer using the Power and Serial cable receiver accessory (p/n: 100182-01).
2. To connect to the receiver in SRU:
a. Click Device
Application Mode
Firmware Loader.
b. Click Device
Connect.
c. In the Connection Parameters window (Figure 18), select Serial Port and the port name, and
then click Connect.
Figure 18: Connection Parameters Window
3. Click the Firmware Loader
icon in the SRU main window. The Firmware Loader window
(Figure 19) displays. This window enables you to upload firmware files to the connected receiver.
4. Make sure Receiver/Modem/Bluetooth is selected in the Device field.
5. (Recommended) Select Soft Break as the Capture Method.
6. Browse for and select the receiver board’s RAM and Flash files (Figure 19 on page 24).