pg. 8
________ 12. Check for leaks at the hose connections as the Softub is filling. If a leak is observed, stop
filling, make sure the hoses are properly sealed and the hose clamps are tight.
________ 13. Plug the HydroMate
®
into a standard, grounded, three prong, 110 Volt outlet.
________ 14. Place the foam hose insulation between the tub and the HydroMate
®
. Attach the vinyl cover
around the foam and fasten with the velcro tabs.
________ 15. Treat and test the water in accordance with the Water Treatment Guide.
________ 16. The Softub is now ready to heat to the desired temperature. Replace the bi-fold lid, close the air
control and adjust the temperature to the desired setting. The water temperature will rise at
about 1°F to 2°F per hour, depending on the model. The Softub will run until the water reaches
the set temperature. You should then fine-tune the dial setting, with the
ꓥ
or
ꓦ
button, until the
preferred temperature is reached.
It is the responsibility of the tub owner to make sure the above installation conditions are met as well
as to follow the safety and warning instructions. Softub Canada is not responsible for any damage,
which may result from water spillage, excessive humidity or structural loading. Please take all
precautions necessary to ensure years of joyful use of your Softub.
