62
EN
ISOM DIGIWARE - 546780C - SOCOMEC
The "INJ" screen defines the general settings in FLD mode:
1) Boost current:
This lets you set the maximum value of the locating current.
It depends on the selected profile.
2) Boost command:
In manual boost mode, this defines how the IMD boost is controlled: via the logical input or via the communication
bus (Modbus or from the ISOM Digiware D-x5 display)
3) Output report:
Activate an output when INJ mode is ON.
4) Activate "mapping" mode (OhmScanner technology)
With "mapping" mode you can track the flow over a selected period; the progress of the insulation by circuit. This
mode is very useful when you start to plan scheduled maintenance actions.
5) Mapping period
Adjust the time interval between 2 measurements generated in mapping mode.
6) Mapping duration
Adjust the boosting time in mapping mode.